Wet leaves, overnight frost and standing water turn ordinary external steps, ramps and decking into the surfaces most likely to catch someone out once the clocks go back. This guide covers which GRP anti-slip product suits each surface, why coarse grit is the usual choice outside, and what to order while the weather is still dry enough to fit it.
Why winter makes outdoor surfaces dangerous
Leaves break down into a slick layer that holds water underneath. Shaded timber and concrete grow a film of algae that never dries between showers. The first frosts then put a skin of ice on anything holding moisture, and shorter days mean staff and visitors are using fire escapes and rear entrances in the dark.
The usual quick fixes do not last the season. Anti-slip paint wears through at the nosing line first, and anti-slip tape lifts at the edges because the adhesive fails when wet. Gritted GRP, or glass reinforced plastic, has the grit bonded into the moulded surface rather than applied on top, so it wears down with the panel instead of peeling away.
External steps
Most slips on stairs start at the step edge. GRP stair tread covers resurface the whole step, the better choice when treads are worn across their depth. GRP stair nosings cover just the leading edge with a gritted, high-contrast strip, the quicker and lower-cost fix when the treads are sound.
Tread covers fit directly over existing steps, are glued and screwed down, and can be walked on immediately after fixing. Each has an integrated 55mm x 55mm nosing and is cut free of charge to the exact width and depth of your step. Gritted GRP is weatherproof and keeps its grip in rain, frost and ice, which is why tread covers are a common fix for external steps and fire escapes.
Nosings come in two profiles, 55mm x 55mm and the slimline 70mm x 30mm for retrofitting, in black, white or yellow. They fit concrete, timber, steel and stone steps with exterior grade adhesive, screws or both, and most installs take a few minutes per step.
Ramps and walkways
A loss of grip on a ramp becomes a fall much faster than on the flat, so external ramps need attention first. The product here is GRP anti-slip sheet, a 4mm thick fibreglass panel with a heavy-duty gritted surface that fits over a sound substrate with adhesive and screws. Stock sizes are 2400mm x 1200mm, 1200mm x 1200mm and 800mm x 1200mm, in black, yellow, grey and stone, and the sheets can be cut to size on site. Coarse grit is the option for outdoor surfaces, ramps and busy walkways that need maximum grip in the wet, and the area should be clean, dry and structurally sound before the sheet goes down. Our guide to anti-slip floor sheets for ramps and walkways covers substrates and fixing.
Timber decking
Decking gets slippery because a film of algae, moss and damp builds up on the boards, and cleaning only removes it temporarily. Our guide to stopping decking being slippery covers cleaning, so this section sticks to the permanent fix.
GRP anti-slip decking strips are 3mm thick with chamfered edges, come pre-drilled with decking screws supplied, and are laid across the boards and screwed down. They are sold in packs of five in 50mm, 90mm and 120mm widths and 1200mm or 2400mm lengths, in black, stone or yellow, and stay grippy even when the timber underneath is wet or green. On busy walkways and ramps, fitting them closer together gives more grip.
Where the boards are past saving, GRP structural decking replaces them. Each board is 120mm wide, 40mm high and 8mm thick in 1200mm or 2400mm lengths, spans up to 1200mm carrying a uniform load of up to 500kg, and will not rot, warp, twist or crack.
Ladders, hole covers and marking
Ladder rungs are easy to overlook until they are wet or frosted. GRP ladder rung covers bond to existing round rungs with adhesive, come in packs of three in 400mm, 600mm and 1220mm lengths, and are safety yellow so each rung is visible in poor light. The 25mm x 25mm profile suits rungs of around 20mm diameter, the 38mm x 38mm profile rungs of around 33mm.
Open drains and small voids disappear under leaves and ice. GRP concrete hole covers are 300mm x 300mm and 4mm thick, sold in packs of five with concrete anchors included, and the aluminium oxide grit stays slip-resistant when wet. They are for pedestrian loads only.
Where a painted walkway line has faded, GRP line marking strip is a 3000mm x 50mm x 3mm safety yellow strip, pre-drilled with chamfered edges, that screws straight down and does not wear away under foot and forklift traffic the way paint does.
Choosing grit, colour and sizes
Tread covers, nosings, anti-slip sheet and decking strips all come in coarse grit for external use or fine grit for internal use. Fine suits indoor areas and places where a smoother finish is preferred. Coarse is designed for outdoor steps, fire escapes, external walkways and high-risk slip areas, so specify it for anything that sees rain, leaves or frost. Our explanation of PTV and R values covers the slip resistance figures behind that choice.
Colour matters more in winter because steps are used in the dark. Tread covers come in black or grey with a yellow nosing, black with a white nosing, or a plain stone finish with no contrasting nosing for heritage buildings and conservation areas.
Measure each step’s width and depth rather than assuming they match. Nosings and treads are cut free of charge from 1000mm, 1500mm, 2000mm or 3000mm stock lengths, so a nosing needed at 950mm is trimmed from the nearest standard length. Standard straight cuts are free; bespoke shapes or complex trimming may incur a charge. Factory cutting also leaves a clean sealed edge, where a rough site cut can leave exposed fibres that weather faster.
Ordering before the cold sets in
The reason to order in autumn is the surface, not the stock. Adhesive needs a clean, dry surface to bond to, and dry days get scarce from November on. Most products are available ex-stock, mainland UK consignments generally go on a next working day service that is not guaranteed, and standard orders received by 12.00pm are aimed at same working day dispatch, again without guarantee. If an item is out of stock or on a longer lead time, you will be contacted within 24 hours with an anticipated delivery date.
Free samples of all GRP products are generally sent out by first class post the same day, so you can check grit and colour against the actual steps. Where adhesive is specified as well as screws, use both, because skipping one is the most common cause of an edge lifting early.
Frequently asked questions
Should outdoor steps have coarse or fine grit?
Coarse. The product pages list it as the external option for outdoor steps and wet environments, with fine grit as the internal option for indoor stairways.
Will frost, ice or de-icing salt damage GRP anti-slip products?
GRP does not corrode, rot or rust, and the guarantee page lists external steps, fire escapes and anywhere that gets rain, frost, salt or cleaning chemicals as exactly the places these products are used.
How long are the steps out of use while covers or nosings are fitted?
Not long. Tread covers can be walked on immediately after fixing, and nosings take a few minutes per step with the stairs usable again almost immediately.
Start with the steps: browse the anti-slip stair safety range and order before the first frost.

